Choose Year
1 Choose Year
Before beginning please read the copy listed below the configurator. This system has many steps that will allow you to tailor a Tie Rod Under Dual Sport Bump Steering Eliminator system to your Bronco's specific lift height and options required to gain optimal steering geometry.
This Dual Sport No Drill system is designed to work with the 1st gen 66-77 Bronco with a factory style or aftermarket equivalent frame, steering gearbox and front axle. Make sure the front axle is factory width, has factory style knuckles and the track bar mount is in the factory location.
To begin configuration choose the year of your Bronco, according to the VIN on the Frame.
Choose lift height
2 Choose lift height
Important - The no drill heim steering only works if you have a factory-style frame, steering gearbox & front axle with factory-style knuckles. If you do not have these 3 things this system will not work for your Bronco.
Lift height will affect which components are needed to correctly configure this system. Each lift height will have different requirements.
Dual Sport Tie Rod and Drag Link
3 Dual Sport Tie Rod and Drag Link
Hassle Free Track Bar
4 Hassle Free Track Bar
Track Bar Drop Bracket
5 Track Bar Drop Bracket
For the system to be mounted Tie Rod Under and have the correct geometry you will need a drop track bar bracket installed at the frame. Choose the one below that is presented if you do not currently have one.
Heim Steer Mounting Hardware
7 Heim Steer Mounting Hardware
For optimal geometry, the No Drill Heim Steering needs to be installed tie rod under (TRU), To accomplish this you will need to select the proper tapered heim studs for your application. You may also choose our 3/4" bolt kit, but it will require you to drill the knuckles.
Lower Coil Retainer
8 Lower Coil Retainer
You can choose either the Standard HD Lower Coil Retainers (5120) or Dual Sport Lower Coil Retainers (5121). If you are not running a Hellwig sway bar then you'll want to select the standard lower coil retainer (5120). The Dual sport coil retainers allow you to install a Hellwig Sway Bar without any additional mounting brackets from Hellwig and allow you to convert the standard sway bar (5311) into a quick disconnect by selecting the proper hardware listed below.
Dual Sport Coil Retainer Sway Bar Hardware
9 Dual Sport Coil Retainer Sway Bar Hardware
5/8" Hardware (5126) - Choose this option if you are installing your (5311) Hellwig swaybar in a non-disconnect configuration.
Quick Disconnect Pins (5127) - Choose this option if you want to turn your standard (5311) swaybar into a quick disconnect sway bar. If you already have a QD Hellwig swaybar (5312) then you must purchase these pins if you are installing our Dual Sport Lower Coil retainers (5121)
Sway Bar Park Brackets
10 Sway Bar Park Brackets
If you are going to disconnect your sway bar you'll need these park brackets
Drill Kit or Tapered Reamer
11 Drill Kit or Tapered Reamer
We recommend either of these tools to ensure clean tapers or holes are drilled.
The tapered reamer is used to clean up the factory taper and use with the tapered studs.
The drill kit is used if you are going to our 3/4" straight through hardware.
